Actually, I use a carpenters level with the weight of it in my hands...I just touch the top of the tonearm head and adjust the rear counterweight so that the bubble is absolutely cenetered. This works if and only if the cartridge stylus was mounted perpendicular. I trust my Benz LP, however, there are many top of the line cartridges that are not manufactured with such precision.
VPI Classic/Clear Audio Maestro Wood Question
I just bought a CA Maestro Wood cartridge from an A'gon member. Per the seller, the cartridge is practically brand new and hasn't even broken in yet. The seller has great feedback and I found him to be very reliable.
I mounted the Maestro Wood myself, being careful to double check alignment, azimuth, VTF and VTA. My turntable is a VPI Classic, with the stock JMW 10.5iSE arm. As far as I can tell, the turntable and arm are in good working order. As regards azimuth, I adjusted it with both the little aluminum rod provided by VPI AND with a bubble balance. Azimuth is perfect. Ditto VTA. Oh, per VPI's suggestion, I am NOT using anti-skating force AND made sure the tone arm wire is not twisted.
After all mounting procedures were performed and double checked, I "eye-balled" the cartridge and cantilever alignment while playing a record. I noticed that as best I could tell, it seemed as though the cantilever was pulling slightly inward towards the spindle, maybe 10+ degrees. Same thing with the cartridge just sitting on a record with the platter not turning. However, when I lifted the arm, the cantilever seemed to hang straight down. Sound imaging is spot center in play mode. Ordinarily, I would have thought the cantilever was pulling slightly inward towards the spindle because of excessive anti-skating force, but as stated above, I am NOT using the anti-skating set-up.
Ok -- the question: Is it normal for the Maestro Wood cantilver to pull slightly inward towards the spindle under the circumstances described above?
One more question: I also own a CA Virtuoso Wood which needs a new stylus and cantilever. Does anyone know who the Clear Audio contact is that does the re-tips?
Thanks for the advice.
I mounted the Maestro Wood myself, being careful to double check alignment, azimuth, VTF and VTA. My turntable is a VPI Classic, with the stock JMW 10.5iSE arm. As far as I can tell, the turntable and arm are in good working order. As regards azimuth, I adjusted it with both the little aluminum rod provided by VPI AND with a bubble balance. Azimuth is perfect. Ditto VTA. Oh, per VPI's suggestion, I am NOT using anti-skating force AND made sure the tone arm wire is not twisted.
After all mounting procedures were performed and double checked, I "eye-balled" the cartridge and cantilever alignment while playing a record. I noticed that as best I could tell, it seemed as though the cantilever was pulling slightly inward towards the spindle, maybe 10+ degrees. Same thing with the cartridge just sitting on a record with the platter not turning. However, when I lifted the arm, the cantilever seemed to hang straight down. Sound imaging is spot center in play mode. Ordinarily, I would have thought the cantilever was pulling slightly inward towards the spindle because of excessive anti-skating force, but as stated above, I am NOT using the anti-skating set-up.
Ok -- the question: Is it normal for the Maestro Wood cantilver to pull slightly inward towards the spindle under the circumstances described above?
One more question: I also own a CA Virtuoso Wood which needs a new stylus and cantilever. Does anyone know who the Clear Audio contact is that does the re-tips?
Thanks for the advice.