2. amps-preamps
  3. 1159731768

Use Krell KAV-1500 to Bi-Amp B&W 801, Possible?

I have a Krell KAV-1500, Krell HTS Processor, and B&W 801 setup. I am considering to bi-amp my B&W 801 using the KAV-1500 multichannel capibility. However, I have hard time to figure how to send identical source to each channel. I could use both XLR and RCA outputs on each channel of HTS to KAV-1500's two channels but there is a 6DB signal difference and I don't like to use RCA. Could anybody share their experience if you have done something similar or just give me some advice? Thanks in advance.
havanese

Showing 1 response by artizen65

artizen65's avatar
Ag insider logo xs@2x
artizen65
272 posts
 
Havanese,

My suggestion would be to contact bluejeans cable or your favorite XLR cable manufacture and see if they would be willing to build you 2 splitter cables to go from your PRE to your amp. It is nothing more than one connector on one end using 2 cables to 2 connectors on the other end. In other words a single channel out of your PRE to 2 channels in on your AMP. Hope this helps.

Good Luck
More to discover