Upgrading interconnects?

Have heard a similar system with MIT,You might look at Silent Source Copper Reference or Purist.

You might be amazed at what getting rid of passive components in the signal path can do.Akin to preamps and amplifiers.These components all contribute something.Correcting phase relationships after-the-fact doesn't make sense to me.
If the speaker was designed around these type of cables,then that is a different story.

Capacitors and inductors effect phase,as any electrical course will teach the student.Thus many of the equations have to do with phase angles/relationships.

I am not speaking of 0/180 degrees,as a subwwoofer filter/crossover.I have heard MIT and the filtering/Band Pass filters do effect the frequency spectrum/sound.Changing out to a piece of wire which does not try to do such sophisticated spectrum/frequency shaping may or may not be an eye opener.
The passive filtering may give a smoother top-end or fuller midrange/midbass,but I can't see how its' attack/sustain/decay characteristics would be better than a straight wire configuration,as a passive component in-line will contribute its' own signature.If the source component,pre or power amplification can't provide what is needed,then fixing it with a filtering network after-the-fact is much like a bandaid.You would need to know what you are trying to correct and not issue a "blanket" filter.As the filter for one system would not be applicable to another.
I don't know that I can explain this differently.It is something that must be experienced.Every system has its' own contribution to the perceived sound.Whether that is to the listeners' preference is another issue and its' adherence to the source yet another.
My two-cents:try it or ignore it.

Just don't pair them with Threshold or wide-bandwith designs,as they can cause these amplifiers to go into oscillation (Noted on the Threshold website).
When you think about controlling a driver,it is about coupling the amp and driver.This is less likely with a filter in-line,as the whole audio signal is passed through it.
Would this not also effect the amount of negative feedback required to keep the amp stable.The back EMF from the driver is at different phase angles,due to the crossover and other items inserted between the amp/spkr combination.
I can understand why these cables are well promoted by dealers,as they can receive up to a 70 point margin.