2. analog
  3. 1353506416

Upgrade Superscoutmaster or Buy Classic 3?

I have a superscoutmaster with the 9 inch signature arm and the older black platter,not the superplatter.

I plan on upgrading it with the classic platter,rim drive and probably the classic 3 tonearm.I could do this in steps,rim drive and platter,then tonearm,or visa,versa.

I could sell the ssc and get the classic 3 which already has the tonearm and the platter.Any thought on which way to go would be appreciated.Since , I already have the ssc, would you upgrade it and skip the classic 3?

My cartridge is a Dynavector XX2mk11 and the phono stage is a Zesto Andros.I had read the review in the magazine enjoy the music of adding the rim drive and the classic platter which took the ssc to a much higher level of fidelity.
Thanks
moonguy

Showing 3 responses by bpoletti

bpoletti
1,525 posts
 
If you're just thinking of selling your table and getting a Classic 3, then that's the route to take. But if you're really interested in performance, then upgrade the SSM.
bpoletti
1,525 posts
 
My suggestion would be to first do the platter. After the platter is complete, then the rim drive since you won't have to fiddle around with the rim drive set-up more than once (it's not really much of a pain, but still...). Then do the new arm.

IMO, the platter will make the most difference.

There are some mounting options to consider with the rim drive. Review all the information you can get your hands on. You may want to consider mounting the rim drive on a "slider" so that it's easier to engage / disengage with the correct pressure against the platter. (Hint: look at the construction of drawers and sliding kitchen shelves.)

If the new platter comes with an entire bearing ass'y, let me know. I might be able to help you get rid of that old platter / bearing assembly.
bpoletti
1,525 posts
 
I agree with getting rid of the gingko.

If the table is using belt drive, consider three Still Points under the table, four Vibrapods under the motor. If using rim drive, get a good shelf system and place the motor / drive assembly on a separate sliding platform. The table and rim drive need to have a solid and stable point of contact. The table MUST sit on a solid platform that won't move. The rim drive must be on a surface that will only slide horizontally but yet have a solid, unwavering contact point with the platter.
More to discover