Two speaker pairs to a single amplifier.

I have a two pairs of Tannoy SGM 10b speakers that I would like to connect with Manley Snappers power amp monoblocks.
According to the speakers specs their impedance is 6Ω (4Ω min.) The power amp specs don’t state the supported iImpedance range:

  • Maximum Output Power into 5 Ohms: 110 Watts (1.5% THD @ 1kHz)

  • Maximum Output Power into 8 Ohms: 100 Watts (1.5% THD @ 1kHz)

  • Recommended Speaker Load: Optimized for 5 Ohms

  • Actual Output Impedance: 1.5 Ohms

Would it be possible to connect two pairs of these Tannoy speakers to the Snappers amps? If so, what would be a proper way to connect them?

- + - + = 8 ohm load (12)
- +
- + = 2 ohm load

in series = 8 ohm (12) YES
2 ohm NO

8 to 12 ohms in series YES
1.5 to 3 ohms in parallel NO

Keep the runs (cables) as short as you can. Will it work? Yes. How well will it work? Don’t know.
May start a hole ne trend! :-)

Just in case it's not clear. If wiring in parallel (which you don't want to do because it will present a troublesome 2-3ohm load to your amplifier), you would simply connect both sets of speaker wires to the amp's binding posts.  To wire in series (presenting a more benign 8-12ohm load), connect the positive wire of speaker A to the amp's positive binding post. Connect the negative wire of speaker B to the amp's negative binding post. And the connect the two "left over" wires together. I use wago lever clips for this purpose. Standard electrical wire nuts is another option, as is "mash together and wrap in electrician's tape".