2. misc-audio
  3. 1232896722

Turntable - On the Wall or to the Floor?

I'm in the process of buying a new analog front end. It was recently recommended to me that I make every effort to put my turntable on a stand that's tied into my "real" wood suspended floor rather than put it on a wall.

I have a 1920 farm house and the floors are loose, wavy, and I can't find a level spot. I once tried my Billy Baggs stand with my old turntable setup and this was scary.

My walls are 2x6 and plaster. I was going to use a Target shelf that's secured to the studs. Doesn't this method also tie the TT to the floor since the studs and floor joists are tied? Any suggestions?
kennythekey

Showing 1 response by inpepinnovations

inpepinnovations
134 posts
 
There is another solution that I have used when faced with a flimsy floor which transmits footfalls to the turntable - hang the turntable from the ceiling with 4 guy wires attached through turnbuckles attached to a large shelf. The turnbuckles are used to level the table.
I placed the shelf-turntable assembly close to a wall where horizontal sway could be controlled through two small springs located horizontally between the edge of the shelf and the wall. Works great. My turntable is an Oracle Alex III. The effect is quite stunning, also, since one cannot see the guy wires, so the turntable appears to be 'suspended' (excuse the pun) in air.

Salut, Bob P.
More to discover