Tubes with Magnepan Atma-Sphere


I'm in the market for an amp for my Magnepan 20.1 and have been looking at Rowland 304, McIntosh 501/402/602, H2O Signatures, Krell 300/400cx, and others. I haven't had the Krell and H20 in my system yet. All of them offer great things like low end control. The problem I am having is when I tried a friends MA1 the sound was just magical. Now the bass wasn't there but the amp was musical as ever. My question is has anyone tried a pair of MA1 monostrapped together for more power (about 300 watts) or a pair of MA2? I know about the heat issue. My wife and I sat down and listened to a McIntosh 402 last night and it wasn't bad but when we put the MA1 back in the system the mids and highs were there. The amp just sounded magical.

Thanks...
muslover

Showing 1 response by slipknot1

The Wolcott P220 monos do a wonderful job of controlling the bigger Magnepan & Soundlab panels. at 220 watts, driven by 8 EL34 based tubes, they have ample power and do not lack at all in the bass department. The most recent vintage of the Wolcotts are now being produced with wider bandwidth transformers than earlier models, and they really allow the Magnepans to open up and sing. I use them with the 3.6R and am delighted with the results. At a little over $10,000/pair new, they are not cheap, but I believe they are a better match for the difficult Magnepan load than an OTL based amp. The Atma-sphere MA2 might work out they way you would like if you consider using Autoformers to raise the impedence load the amp is seeing.
I can tell you that I have no need for a sub in my 17 X 23 X 10 room using the Wolcotts.

I have had an opportunity to listen extensively to the MA2 amps driving Avalon Eidolons and can attest to the fact that they do not lack in the bass arena at all. A wonderful amp that seems to get everything right.

If you have the opportunity to do so, try to listen to both the Atma-sphere and the Wolcott driving panel loudspeakers.