2. amps-preamps
  3. 1286686656

tube amp help

I recently purchased my first tube amp- a used Audio Research VS 110 with new matched SED winged C 6550Cs put in by the seller. They were biased at 55mV per his recommendations. I've been listening for 1 week- it sounded great until today. When listening there was a brief pop sound and a quick spark from tube 7. I turned it off, waited a couple hours...turned it back on, they all glowed orange, I checked the bias. tube 7 had 0 mV, all others 53-55. Is the tube blown? Do I need just need to reset the bias? If I need to replace the tube do I need to replace a pair?? Any help would be appreciated - I am a tube amp newbie.
jjb67

Showing 1 response by dusty

dusty
60 posts
 
Arizona Hi-Fi is an ARC dealer. You might want to take the tube (and the amp) down to them to check the tube(s) and verify that the bias resistor is okay. If you're lucky, all that will be needed is a new tube. Also, having the dealer check ALL the tubes will verify that they are new tubes.
Don't laugh, I have replaced tubes in my used tube amp purchases with fresh tubes purchased by me. The tubes that came with the amps didn't see duty until I checked their condition. Some of them were on their last legs.
More to discover