I had great success using the VTL MB 250 amps. The ST150 was still straining with my 1.6's but the 250's were awesome. I used them when I upgraded to the Maggie 3.6's. The system had plenty of dig on the low side and was just as good all the way up. Maggies need the power. Also the VTL's have a fixed 5 ohm tap for the output.
Tube-amp for Magnepan?
Hi.I have currently tested Audio Research VT60 with my old Maggies (MG2A),
It seems that the 50w is too weak in power.I experienced a lot of distortion already at "10 oclock"-position on the preamp.(could there be something wrong with the tubes?) At low volumes it sounded fantastic!
The 4ohm connection was a lot worse than 8ohm.The Maggies are 6 ohms...
A friend suggested either a VT100 from AR or maybye Mcintosh 275.The latter is more in my budget..I currenty run a Papworth MIA200 ,200W solid state-quite good but a bit boring.I really want to test out tubes!Have anyone any recomandations?
It seems that the 50w is too weak in power.I experienced a lot of distortion already at "10 oclock"-position on the preamp.(could there be something wrong with the tubes?) At low volumes it sounded fantastic!
The 4ohm connection was a lot worse than 8ohm.The Maggies are 6 ohms...
A friend suggested either a VT100 from AR or maybye Mcintosh 275.The latter is more in my budget..I currenty run a Papworth MIA200 ,200W solid state-quite good but a bit boring.I really want to test out tubes!Have anyone any recomandations?