2. amps-preamps
  3. 123729-78800

Too much power?

Forgive me for what is probably a silly question.
I've been out of the entry level audiophile scene for nearly 17 years and I'm not sure about the set up I'm currently running as I had to replace my mains.
Long story, short, I had a pair of M&K S-125 speakers stolen 2 weeks ago when my house was burglarized. I decided to try something different and bought a pair of Definitive Technology SM45 speakers. I'm powering the SM45 speakers with a Parasound HCA-3500. I'm using an old Yamaha RX-V592 as a preamp. Between the Yamaha CD player I installed a Musical Fidelity X-ACT DAC followed by a Musical Fidelity X-10D (for a little warmer sound). All cables are by Monster Cable.
To me it seems that I may have too much power driving the speakers. The reason I believe that is that the volume dial does not have to move more than 75 degrees up from 0 to have the system on the loud side. The speakers are rated at 150W and the amp is rated at 350W.
Am I over-driving the new SM45 speakers?
Should switch over to the Carver TFM-35 I have powering the M&K S-80 center speaker?
Your thoughts would be appreciated 
exiledviking

Showing 1 response by tbg

tbg
5,263 posts
 
exiledviking, every component from phono stage, line stage, DAC, and amps has gain. What everybody is saying from it is unlikely that you will have a problem to the amp can burn out your drivers is true. Once because I was intrigued by a 200 watt tube amp, I tried it on my 103 db efficient speakers. I was very careful about the volume, but the sound was awful. The amp's noise was just too much into these speakers.

Your speakers are probably about 86 db efficient which is pretty low, so I don't think they are the problem, nor do I think the amp is, but I do think the preamp probably got too much gain and the pots for volume control are insufficiently resistive. 

More to discover