tonearm mass/cartridge mismatch


What would happen if the tonearm mass is too low or too high for a given cartridge? What is a less disastrous mismatch: a heavy tonearm with a light(less than 10 grams) high compliance cartridge or a light tonearm with a heavier and low compliance cartridge? Whould the combination of a heavy tonearm and a light cartridge lead to a lower resonance frequency?

Chris
dazzdax
Look up the numbers at http://www.cartridgedb.com/
It would help, if you know the specs of your equipment, since I've seen some wrong ones there...

Misha
is a less disastrous mismatch

A heavy Tonearm with a light cartridge is the better way to go.
One of the main mismatches today is for example the light Triplanar with a heavy Koetsu cartridge.
The relative weight of the tonearm and cartridge is not the determining factor in resonance. The resulting resonant frequency is determined by the combined effective mass of the arm and cartridge along with the compliance of the cartridge.
I didn't think any of these combinations mattered as long as the resonant frequency ends up between 8-12 hertz?
I didn't think any of these combinations mattered as long as the resonant frequency ends up between 8-12 hertz?

Well, it is only 1 information. Arm tubes today are made of Ceramic, different Wood, Titanium, Steel, Aluminum, are damped or not, then there are different qualities of bearings and some more...
If I'm using the relatively heavy SME 3012 Series II 12 inch tonearm with the Transfiguration Spirit Mk II cart, could I reduce the tonearm mass a bit by using a light magnesium headshell? Is that recommendable? Thank you.

Chris