tone arm with 10gr mass with 15 gram weight cartridge?

thanks

Shucks. Ah jest tapes a penny to the top of the headshell and calls it good. (Oh wait, it's no longer April 1st, is it?)

This is my last attempt to advise, Just do it.

lewm
i of course appreciate your advice , and will use it after i'll decide wich cart i prefer

I went down this rabbit hole of concern when I had to buy a new turntable.  I wanted to use my very light Soundsmith SSMC1 B&O cartridge on a table with a much heavier arm than the B&O table.  I bought the table before I realized this might be an issue.  I never got an answer from forums to my question of, compliance charts notwithstanding, what I might actually hear with a bad compliance match.  I talked to Soundsmith and went for it, using their nylon screws to keep arm weight down.  They advised, assuming the counterweight had enough travel, azimuth and anti-skate would be most important.  I almost ran out of adjustment on the anti-skate, but It sounds fantastic.  I haven’t noticed any resonances if they are there.