2. analog
  3. 1251355720

tone arm drifts towards the outside when lowering

I'm setting up a new table and cart. set the alignment, VTF, VTA and it sounds very nice.

When I lower or raise the tone arm it "drifts" to the outside.

It tracks fine on the record.

thoughts?
relsteamboat

Showing 2 responses by relsteamboat

relsteamboat OP
4 posts
 
thanks everyone.

I removed the anti skate and the problem went away. not sure if I can hear a difference or any issues with tracking.

table is level and I triple checked the VTF -- all good.

will try cleaning the lift

the table is the pro-ject RM 10 with a shelter 901 cart.
relsteamboat OP
4 posts
 
Problem resolved --

I cleaned the lift -- it was dusty/dirty.

My mistake on the set up -- I had the anti skate set up prior to adjusting the VTF.

Those two simple changes did the trick.

Thanks again everyone.
More to discover