Socrates, it's quite UNlikely that a replacement driver will match sufficiently in sensitivity to provide excellent imaging. Dynaudio et al sell their mid-spec runs to OE manufacturers and sell the production "tails" to hobbyists, etc. I guess you could use a RS meter afterwards, and retweak the cross-over with a driver pad if necessary. But what a chore....
Time to replace speakers, suggestions wanted
I have enjoyed my Totem Rokks for about 8 years now. Recently I noticed the distinctive sound of the paper separating on the left mid-range. So I will start the search for replacement speakers and will limit my search to full range towers. I listen to mostly rock from acoustic to hard and I am looking to get back into vinyl soon. Fidelity is important. I have heard Aerial 7B's and was very impressed. They might be a bit much for my system. I would appreciate input on speakers to audition.
My system consists of Marantz 63SE CD, Adcom GDA600 D/A, Rotel RC-990BX pre, 2 bridged Rotel RB-980BX amps (horizontally bi-amping to keep leads as short as possible), all fed by a Rotel RLC900 line conditioner. I also have a Paradigm powered sub, but I hope this will go away.
My listening room is the 15x20 L part of my finished basement. Berber carpet, bare (for now) walls, and 8' drop ceiling.
My system consists of Marantz 63SE CD, Adcom GDA600 D/A, Rotel RC-990BX pre, 2 bridged Rotel RB-980BX amps (horizontally bi-amping to keep leads as short as possible), all fed by a Rotel RLC900 line conditioner. I also have a Paradigm powered sub, but I hope this will go away.
My listening room is the 15x20 L part of my finished basement. Berber carpet, bare (for now) walls, and 8' drop ceiling.