Agree with RW. After you are done, with all the time and labor invested, the cable you created won't be cheap anymore. Also the result isn't guaranteed. I don't know how many people here are expert cable engineers. I know I am not and I doubt you are either or you won't be looking for opinion here. So unless you are trying to enter cable making business and are researching the possibility, what is the point?
Thoughts on very cheap speaker cables
Hi all,
Has anyone tried speaker cables made as follows:
1. 4 single 12Ft strands of 22 AWG certified OFHC CDA
101 annealed temper copper ($0.25 a foot).
2. Each inserted in pure lowest dielectric woven cotton.
3. Each assembly inserted in lowest dielectric PTFE tubing.
4. The ends will be sealed with a PTFE sealant.
5. About 1" of bare wire will protrude from the sealed
ends, coated with a low dielectric antioxident.
This will provide a twisted pair, held together with shrink wrap, for each B&W803N speaker connected directly to an Aragon 8008bb amp. All thoughts will be greatly appreicated.
Thanks,
Henry Rancourt
Has anyone tried speaker cables made as follows:
1. 4 single 12Ft strands of 22 AWG certified OFHC CDA
101 annealed temper copper ($0.25 a foot).
2. Each inserted in pure lowest dielectric woven cotton.
3. Each assembly inserted in lowest dielectric PTFE tubing.
4. The ends will be sealed with a PTFE sealant.
5. About 1" of bare wire will protrude from the sealed
ends, coated with a low dielectric antioxident.
This will provide a twisted pair, held together with shrink wrap, for each B&W803N speaker connected directly to an Aragon 8008bb amp. All thoughts will be greatly appreicated.
Thanks,
Henry Rancourt