the dreaded breaking of tonearm wire...now what?


I just got a new (used) benz micro h2 in the mail and began my first install. Needless to say, didn't go very well. Actually, except for one tonearm wire breaking, it wasn't as bad as I thought.

So, is there anything I can do to salvage it? Or, should I just send it somewhere, or just a new tonearm cable? It's just the stock in the MMF-5, but don't have a budget right now for anything much better.

What would you do?

Good news: even though I only have sound through one channel, it already is an incredible difference. I think I need some extra counterbalance weight, as the force is tough to adjust. But already much better, except for the fact there is no soundstage with one speaker..

Thanks
pablo16

Showing 5 responses by pablo16

Tpsonic...Just was able to pull out a little more of the white cable...there is enough to solder it back...Any tricks, methods, etc?

Thanks,
Paul
Dan_ed: Where did you get the wire and clips...I'm thinking this might be a good time for me to do the same...

Also, I think i'll be able to use the same heat shrink, that is if I can get it back on the wire...
Audphile....It really wasn't too bad. The clip on the white wire was stuck just a bit, and when it finally freed loose, it just shot off and snapped the cable in two. I've heard of people using toothpicks to help loosen them before pulling with the needlenose pliars (make sure it's a fine pair of needle nose). I've heard of others putting some substance on the clip to help loosen it up as well. Just be careful, steady, and just pry the clips off slowly, don't pull. I learned my lesson with the other 3
Got the connection soldered back today...works just fine, though not the prettiest connection.

I think I'm going to either do a re-wire or look into one over the next couple months...but, for now, I'm happy...Thanks y'all!!
Aud,

I am loving the Benz...It's smooth, silky, quiet. It's high's and lows reach much higher than the Goldring. The whole entire sound spectrum is a new beast now. It's incredible what a difference it made. I know it's not the best table and arm, but the cart has made me very happy with my setup now. Still need to tweak a bit, but overall, it's magical.
Paul