Technics SP-10mk2 oscillations


A peculiar thing going on with my SP-10mk2. Without the platter, the rotor oscillates  at high frequency and amplitude while turning at 33rpm. At 78rpm, the oscillations are much less so. With the heavy platter on, oscillations disappear. No gridding noises, etc. Anyone experienced a similar issue or can share any helpful tips? Thanks in advance.

Ray

 

rays19

What Best-groove said.  What you observed, rays, is normal and not a good idea in practice. The servo system needs the mass of the platter in order to operate properly.  The herky jerky motion of the rotor without any mass on it is what to expect.

Without the platter, the rotor oscillates  at high frequency and amplitude while turning at 33rpm. At 78rpm, the oscillations are much less so. With the heavy platter on, oscillations disappear. No gridding noises, etc.

@rays19 The servo 'hunts' without the flywheel effect of the platter. That's why it jerks like that- and many direct drive turntables do exactly the same thing. You got good advice above!

Some manufactures state,

"damage may occur if running with plater removed"