2. analog
  3. 1248103609

Technics SL1200 Cardas REWIRE Shielding

I am currently looking to rewire my tone arm. I know that cardas makes a nice litz wire for rewiring tonearms. I have a bit of a technical question. I am hoping to use a shielded wire and I was just curious how to connect the shield within the wand and tonearm assembly?

Does anyone know of a good source to get a spool of this wire, in either shielded or unshielded format?

I believe the wire has the following flow from inside out.
Litz->dilectric enamel-> 4 straight->1 shield for all 4->dilectric.

It sees as though if I had the left and right independently shielded then I would be able to connect to the cartridge as follows left signal left ground, right signal right ground. But since there is only one shield I am uncertain of how to do this properly. Some advice would be greatly appreciated! Thanks a million guys looking forward to hearing from you.
dfelkai

Showing 1 response by johnss

johnss
564 posts
 
The cardas will make a big difference, but you can not used shielded wire in the arm; too stiff. I would not mess iwth it. Box up the table or the arm and send to KABUSA dot com; and let Kevin do the re-wire for you. Can not speak highly enough of him.

best
More to discover