Speakers near fireplace


I’m moving and in the new house it seems the best speaker position would be to have them on each side of the fireplace. They’re Vandersteen 2CE Signatures. I want to put them about a foot or so to the right/left of the fireplace and about 1-1/2 feet in front of the wall with the fireplace.

There are glass doors on the fireplace but I’m thinking of replacing that with a screen.

I would plan on putting the amp, etc. further to one side of the left speaker. The only real problem I see is that there will be a cable running across the floor (in front of the fireplace) to the right speaker. That and I will have one speaker close to the amp. In the past my rig was basically in the middle of both speakers, what’s the best way to handle 12’ of cable with only 2-3 feet needed on the one side?
jetson

Showing 2 responses by grannyring

I have the same issue as you. First, I ran the cable under the floor/house so there would be no cable visible between the speakers. My wife did not want to see the wire. Used nice wall plates that the cable passed through both going down and coming back up. The long cable ended up being 20 feet long. My shorter cable is 7 feet long. No need for both cables to be the same exact lenght. I used a nice 10 gauge speaker cable that I manufacture and sell and my system sounds wonderful. No worries about uneven cable lenght. I cannot hear the difference between equal lengths and my current set up. I have done the listening tests. No difference at all.

Perhaps you could do something like this? It would be nice if the length differences were minimized as much as is possible.

You can view my system under virtual systems here.  
Gas fireplaces with no blower should not impact speakers at least 4 feet away.  My gas unit is all about the aesthetics of the fire as without a blower I cannot feel the heat until I am right up to it! Is yours gas? Blower? Take the temp at the side and back of your speakers and you will know for sure.  4ft away the temp is 75 when my room is 72.