Speaker Isolation -- Experience with Townshend Seismic Isolation Podiums


Over the past several months the new Townshend Seismic Isolation Podiums have been receiving some interesting and positive press. Living as I do in both an earthquake zone (Pacific NW) and in a busy urban setting with a lot of rumble from construction and passing vehicles I thought these could be worth exploring for my setup. As I was not able to find a US distributor I purchase direct from the UK (via Analogue Seduction, highly recommended). I placed an online order, with follow up to confirm the size and weight of my speakers and about six weeks later they turned up on my doorstep (the platforms are made to order with loading on the cells specific to the weight of your speakers)

The Isolation Podiums are basically four load cells attached to a robust platform onto which you stand your speakers. While not cheap ($2500 for the size I needed) they are very well designed and easy to use. For example I was concerned about being able to move my 275lb Magico Q3s up onto the platforms -- actually it was easy as the platform at 20mm is lower than the speaker spikes so it was simply a matter of unscrewing each spike and shuffling the speaker across. Once onto the platforms fine leveling was easily possible by adjusting each load cell. All in all the podium system is very well designed and works exactly as intended.

But how does it sound? With several days listening experience I cannot recommend this product too highly for anyone who wants to hear the best from their speakers. My room is custom designed with a concrete slab floor so a solid surface but of course subject to external vibration. Prior to the podiums I'd been enjoying deep and dynamic bass but had occasionally felt that the sound became congested in more dynamic and complex material. With the podiums all of this clears up. First impression may be of less bass but as is typically the case this was a result of a reduction in boom and smear and instead more of the open sound of real bass (think of a bass drum as being more "whoof" than "thump" after the initial leading edge - too often the sense of large volumes of air being displaced is lost. In addition I became much more aware of all the rhythmic leading edge detail in bass guitar passages, all the little cues the bassist is putting in. Furthermore it became much easier to resolve bass alongside other instruments. Example in point "Bye Bye Blackbird" by Nancy Harms (https://www.youtube.com/watch?v=yd4tQrndlFw). This opens with deep full bass which is a first test but then quickly becomes quite a crowded and in many systems overloaded mix. With the podium in place all of the instruments became much easier to separate and what had been a congested and even edgy mix became clear.

One final and unexpected change is how you can now more easily hear the recording venue. Listening at the start of recordings the sound of the room itself is a very low level mix of rumbles which (when it's present on the recording) is all too easy to lose -- the podiums help uncover this detail and create a much greater sense of real instruments in space. All in all I'd recommend you give these a try and no need to believe in voodoo to buy in to this tweak.
128x128folkfreak

Showing 9 responses by david_ten

Seismic Bars versus Seismic Isolation Podium???

Has anyone compared the Bars vs the Podium for their speakers?

The Bars are priced lower than the Podiums.

I'm also considering the Isoacoustic Gaia I for speaker isolation. Have any that have used the Townshend products compared them with the Gaia?

Any general updates on the Podiums by members who have posted here, since it's been over a year and a half from the OP and six months since the last few posts?

Thanks. 
Great to hear that the Podiums continue to be a worthwhile addition to your system's performance.
@folkfreak   Thanks for your response. It would be nice getting a read on how close the Seismic Bars perform to the Podiums. Do you have any suggestions on who I may be able to reach out to from Townshend (/US Distributor) or a dealer? 
Good reads. Worth isolating? : )

"Koelemeijer’s seismograph would spike some mornings, when a neighbor’s washing machine would hit the spin cycle. Even in the depths of the quietest period of human history, “human environments aren’t really ever completely silent" [Copied from the MIT Technology Review, linked below]

Highlighting the above as many point to electric grid use during peak / daytime hours negatively impacting system performance.

Human activity, of the seismic kind, decreases at night...which (likely) also contributes to improved system performance (late night to early morning). Another factor to consider.

https://www.technologyreview.com/2020/07/23/1005574/lockdown-was-the-longest-period-of-quiet-in-human-history/

https://www.washingtonpost.com/science/2020/07/23/human-seismic-noise-coronavirus/
@folkfreak  and other members who are using the Seismic Isolation Podiums / Platforms:

My speakers (Cube Audio Nenuphar) are bottom ported and are designed with a tilt (higher in the front). They come stock with spikes in front and small rubber bumpers in the rear. There is a gap from the floor of approximately 1.5 inches in the front and 0.5 inches in the rear.

Has anyone used Townshend's solution with the spikes on the speaker? Can one 'spike' directly to the platform or is it best to use a protective puck?

I've emailed Townshend regarding the same. 

Thanks!
@shaizada   Thank you!

Platforms, then! : )

Are the platforms thick/solid enough to take the spikes directly? Or should I protect with spike protector discs?
@shaizada   You've been very helpful. Thank you. I'll report back with results.
@folkfreak  Thanks. 

I also heard back from Sue (Townshend), confirming your and @shaizada 's advice. 

"You can use the Podiums with spikes, without spikes or with pucks."