Speaker and amp selector box?


Wondering if there is a selector box that can match different amps with different speakers effectively. I have 3 amps and 3 sets of speakers that I would like to match differently with each other from time to time. Would like to not compromise quality and a search has shown some cheap wire insert boxes for speaker connects to run multiples of speaker pairs simultaneously.( iow just want to vary the amp for a given set of speakers).

....I wanted to add that I have only one source, one set of monoblocks and 2 other stereo chassis.

Thanks
recluse
Would like to not compromise quality and a search has shown some cheap wire insert boxes

"Would like to not compromise quality....... cheap wire insert boxes."Is that really what you meant to write? 




Not sure if you’re questioning my grammar but I would like to avoid this
(Look at the back side)
https://www.parts-express.com/moderno-ms6-6-zone-speaker-selector-switch--299-4064

You know, those speaker connector tabs you had when you were a young audiophile;-)

Is there something of better quality , bananas at least?
This one uses banana plugs. 
2 Amp x 3 Pair Speaker Selector Switch Switcher Volume Control, https://www.amazon.com/dp/B00XUM9OAM/ref=cm_sw_r_cp_tai_99qDEbXJGAXEN
Thank you for the link, both the same?
Any experience with this item?
Any without ?passive? volume control.
Any others of higher quality with less interference of the signal.path?