There's been a myriad of good discussion on terminations for high end speaker cable. Spades vs Ban vs bare wire etc. After much deliberation, the variability in termination contact material and the cost, my conclusion is to forgo any spade/ban termination and run bare 12 awg 200+ strand OFC copper wire. I plan to simply treat the connection with Caig Deoxit D and Gold series.
According to their literature the connection is protected on average 5 years.
https://caig.com/questions-answers/#toggle-id-2Its not the neatest setup, but this is a set it and forget it home audio set-up with sub $5K in equipment in a climate controlled basement that stays 68 degrees year round. I'm new here and in no way poo-pooing the decision for terminations. For me, it seems like work I don't need to take on unless someone told be the channel output could be increased by a few db and the distortion decreased by 20+%.
Anyone see an issue with this reasoning?
Other post history:
https://forum.audiogon.com/discussions/spade-vs-bare-wire
