Soundcraftsmen Amp help


Hey all! Noob question here. I just picked up a Soundcraftsmen 300X4 amp. This is a 4 channel amp, but I’ll just be using 2 channels for a stereo setup (left and right). The speaker connections are labeled A, B, C, D. No mention of left/right. Would I connect my left Speaker to A, and right Speaker to B. Or Left speaker to A, and right Speaker to C. Here’s a pic...
https://photos.app.goo.gl/2HRz34xxB9r7H3Bi7

I assume:
A is front left
B is rear left
C is front right
Dis rear right

is that correct?

6c9f6c9f 3fe3 4d12 afe9 a1ff83ee91a5cdm418
Wow. That picture is crystal clear.
You could use any two of the inputs, but I'd go with A + C based on the bridged channel assignment in case there are two separate power supplies. You could also operate it in bridged mode which would give you much more power by combining (A&B for left channel) and (C&D for right channel). You then have to follow the input and output connections as marked for BRIDGE mode. You will gain a lot of power but when operating in bridged mode the amp sees an effective impedance of half of what the speaker load presents, i.e. if you have 8 ohm speakers running them bridged the amp sees 4 ohms in each channel. Likewise if the speakers are 4 ohms the amp sees 2 ohms in each channel. So the amp works much harder in bridged mode and in my experience with SC amps bridged the fans will operate more often at higher speeds and be much louder than only running the amps in their standard non-bridged mode.

Awesome!  Thanks for taking the time to answer!