What’s interesting is, when my contractor went to source subpanels here in Austin for a "from scratch" install, the supply houses claimed they had Square D with copper buss bars, and upon examination, all were aluminum. When I was in NY metro, it wasn’t a special order and readily available at local suppliers.
I think I wound up w/ Cutler Hammer w/ copper bar.
I never compared aluminum v. copper, just followed what i understood to be good practices. (I know, the way of sheep). But, the electrical subsystem I had the contractors install in the past year is great; ironically, even the ’dirty’ power here (without the big iso transformer that got installed in the backyard) was pretty quiet, even though I’m essentially "in town" in a residential neighborhood. I think there are a lot of variables, starting with the quality of the power coming in from the pole, and then following good practices--I am a big fan of @jea48 ’s input on this board, b/c he isn’t proposing ultra expensive audiophile solutions, just basic above code quality and practice.
I think I wound up w/ Cutler Hammer w/ copper bar.
I never compared aluminum v. copper, just followed what i understood to be good practices. (I know, the way of sheep). But, the electrical subsystem I had the contractors install in the past year is great; ironically, even the ’dirty’ power here (without the big iso transformer that got installed in the backyard) was pretty quiet, even though I’m essentially "in town" in a residential neighborhood. I think there are a lot of variables, starting with the quality of the power coming in from the pole, and then following good practices--I am a big fan of @jea48 ’s input on this board, b/c he isn’t proposing ultra expensive audiophile solutions, just basic above code quality and practice.