Sony amplification sufficient to drive GP Homes?

Ryder,

I think it's a just matter of degree. In home theater, it's important to achieve maximum dynamic range in the system and to avoid distortion. You have to use bass-management properly to achieve this. Your Sony amp would most likely sound very good in your proposed system IF you apply proper bass management. I would suggest you set all channels to "small" and subwoofer "on" (assuming you have a powered subwoofer (or two!). Even if your main speakers are large floor-standing hulks, set them to "small" for bass-management.

Set your crossover to either 80hz or 100hz depending on the in-room bass response of your mains. Dial in the proper volume for all speakers and sub using a SPL meter and voila! - your TA-N9000ES will coast through the most demanding movie soundtrack without breaking a sweat.

JZ.

Ryder,

Glad to help. Hope you had a nice holiday! By the way, if you utilize the electronic crossover in your processor for bass-management, be sure to use the unfiltered input on your sub (usually labeled "LFE" or set crossover to "external/out") if it has this feature. Otherwise, turn the active sub's crossover to it's highest setting to get it out of the way, then blend the sub's output to your mains using it's volume and phase controls.

But I cannot take all the credit here, this advice is right out of the THX handbook. They've done all the homework. In fact, many people do not realize that on a THX-equipped receiver/processor, engaging THX mode will override the user's bass-management settings. For example, if you tell your receiver that you have "large" front speakers, a "large" center channel, etc. during intitial setup, that's what you will get listening to Dolby Digital/DTS. But as soon as you engage THX processing, THX will (among other things) override your settings and set all main speakers to "small" and sub to "on" with crossover set to 80hz. Pretty cool, huh?