Small issue with one channel of my Krell Evolution Two Pre-amp! Any Simple suggestions???


I have a question regarding my Krell Evolution Two Preamplifier.

I noticed when I powered up my Evolution Power Two from standby today, I received the following messages on the front of my right channel unit.

First it said:
DC offset found

Followed by:
Checking Outputs

Followed by the following two messages.
Cast Out 1
Cast Out 2

Finally it goes to S1 which is the default output.

Then I can just hit the B1 output as usual to my matching Evolution One Mono Blocks.

Music plays as normal with no issues. Is there something I need to address? Should I be concerned at all. It would cost a lot to ship back to Krell from Canada and was hoping it was an easy fix from my end. Any insight or help would be greatly appreciated. The sound is fantastic as always just the few seconds longer to boot up.

I rarely use the cast cables as I prefer my balanced interconnects more.
usherzaleg

Showing 1 response by usherzaleg

Thanks getting back to me. I had changed the power cords to both the pre and power amps on Friday with custom cables. I took those out of the equation from the Pre-amps since the error message was coming from them without success. Decided to put the new cords back onto the preamp and try taking the new power amp cords off and replacing them with the OEM... Success. There must be a problem with the 20amp iec connector on the new power cords. It was very hard getting it to plug in all the way and is quite large and heavy and I guess doesn't remain seated completely. I'm just happy the issue is gone. Had me sweating.Thanks again for your suggestions.