I run my N802's single wired, sounds more coherent and a better soundstage than bi-wired. I've tried using both sets of terminals and various jumper wires and settled on the bottom (woofer) terminals as the main input and use the B&W supplied jumper wires to the mids/tweets. You can do a lot of fine tuning with jumpers. I have five different sets.
Single wiring bi-wireable speakers
Dumb question, but which binding posts should I use for connecting the speaker cables? Top or bottom? I've always bi-wired, so I've never thought about it. Anyway, I've put the gold grounding straps back in place.
(I've promised a fellow Gonner that I would A/B my Talon Khorus against Newform Research R645's. I want to use the same cables and since the Talons cannot be bi-wired, I'm running the tests with single runs of Kimber 8TC.)
This should be a one reply thread (unless someone starts throwing tomatoes at my innocence).
(I've promised a fellow Gonner that I would A/B my Talon Khorus against Newform Research R645's. I want to use the same cables and since the Talons cannot be bi-wired, I'm running the tests with single runs of Kimber 8TC.)
This should be a one reply thread (unless someone starts throwing tomatoes at my innocence).