Should I use long interconnects, or long speaker cables?


Currently, my equipment rack is placed centered between and behind the speakers.  I’m getting acoustic feedback (rumble) from my tt due to it’s location.  Successfully, I have eliminated this rumble by using a KAB rumble filter.  However, this seems to me like a bandaid approach, and I would like to try to eliminate the use of this filter if possible.  I’m thinking of moving my equipment rack to the side wall to try to eliminate the rumble filter.  My question is, there are two ways to do this.  Is it best to:
#1). Move everything (including the amplifier) to the side wall, and use long speaker cables to connect the amplifier to the speakers.  
#2. Move everything, except leave the amplifier on the floor (on a separate amp stand), and run a long interconnect (20’-25’) from the preamp to the power amp (my preamplifier is single ended only)?
In advance, thanks for your guidance!
louisl

Showing 1 response by aj523

I’m not buying the long 20 foot speaker wire degradation issue. I have 50-75 foot daisy chain runs of 12 gauge copper to my super high end outdoor speakers and they sound phenomenal. Or buy anti cable - they tested identical in long vs short runs.