Shipping B&O RX2 Turntable

Without original factory packing materials, how to prepare platter and integral tone arm for safe shipping? Any suggestions how to box up so turntable, platter and tone arm survive the journey?


Thank you Steve,

With this belt drive and both the platter and tonearm supported on the same spring- supported sub-chassis, how best to prevent the tonearm from constantly trying to jump due to the underlying spring?

If the "pink" is inserted between the rigid top plate/top surface of the turntable and the sub-chassis can this prevent trampoline jumping in transit? Is the platter packed separately so it doesn't add mass to the sub-chassis during shipping?

Also, the clear attached plastic dustcover cannot be removed according to an acquaintance who could not put the cover back on once it was removed. so best to leave attached. (When record being played, the dust cover is temporarily way up out of the way for better sound.)

Sorry that there are more questions, but ignorance is not audio bliss.


Joel - For the Tone arm see this link for arm support

For the platter I would layer a coule of pieces of "pink" so that they hold the platter in place and use the lid to prevent the platter/pink from coming out - you could t a couple of pieces of foam over the platter to prevent bounce

Looks like B&O leaves the platter in place from the pics in the link above

Hope that helps

Steve, thanks for your continued help.

If any Audiogon member has personal experience to add, then please add their shipping experience.

I will be receiving the shipment, and need to provide guidance to the seller so the RX2 reaches me in great shape.


Here is the owner manual.
See, "Setting up after unpacking".
Note, the platter should be locked in place by 3 rim brakes. 3 transports screws lock the spring suspension in place.