Here is the instructions:
Cartridge loading is achieved via internal
dip-switches. Factory setting is 100
ohm, zero capacitance.
Two 6-row dip switch banks are located on the board. Loading is as follows:
- Dip Switch 1 up = 100 ohm;
Dip Switch 2 up = 100 ohm.
- Dip Switch 1 & 2 up =
50 ohm.
- Dip Switch 3 up = 1K; Dip
Switch 4 up = 1K.
- Dip Switch 3 & 4 up =
500 ohm.
- Dip Switch 5 up = 47K; Dip
Switch 6 up = 100pf.
My cartridge is Clearaudio Concept MM. Specs say: Loading impedance : 47kw Loading capacity : 100pf.. I put dipswitch 5 up,should 6 be up ? It sounds good,but I have some hum and my woofers seem to be fluttering quite a bit also. If anyone could help it would be much appreciated. I did email manuf. but havent heard back yet.
