2. amps-preamps
  3. 1204287063

Second failure of new amplifier

Two weeks ago I burned my new amplifier equipped with eight 6L6 tubes. I had been using the amp for one week before that and everything was OK. The failure occurred when I was switching the amp to the standby position and then to the "off" position (two small tubes and two central power tubes flared, so I switched it off and disconnected from the mains immediately). Switched on - no sound. I found out then that the failure was caused by one damaged 6L6 tube and one burnt fuse.

I replaced the fuse and one tube and everything was OK, until I decided to listen to the music today. I listened to it for 15 minutes, then the same problem occurred - when I was switching it to the standby position and then to the "off" position, there was a clapping sound, one 12AU7 tube ignited (flared strongly) and the tubes do not glow after switching on. I will explore this problem further when I come back from work.

When I was purchasing this amplifier (I would prefer not to disclose the manufacturer), my local dealer claimed that the amp had a "stabilized power supply design" or something like that. One of my audiophile friends dissuaded me from bying this amp, saying that 4 output tubes per channel may cause a problem. The dealer said "don't listen to him - he does not know what a "stabilized design" means."

I think I know now what is "stabilized design" - it's burning fuses and tubes every second day. My dealer is reluctant to take it back even for resale (I suggested that he took it for repair and sold it and only after that give me money), but he claims that the guarantee is void because I replaced the stock tubes (12AU7 and 6922) with my own (vintage)tubes and that I should have waited for a couple of months (while it was burning-in) and should have used it with stock tubes without replacing them for other tubes. He added that according to the European ISO standards, changing the tubes would void the warranty.

My questions are:

1. Does tube-rolling in a new amplifier always void the warranty?
2. Is it true that the auto-bias function (especially when the amp is powered with so many (8!) output tubes is unreliable as compared to manual bias adjustment (like my other amp - Cary SLI-80)?
3. Is it normal when a brand new amplifier behaves like this?

I will appreciate all comments, opinions and suggestions.
transl

Showing 1 response by davidsss

davidsss
43 posts
 
I have a new amp and have had tube failure. I am new to tubes an did not replace the tubes. These things can happen. But the service I expect is the service I'm getting - the importer came to my house, replaced the tube (and the other one in the pair for a match) and the fuse. Unfortunately it seems to have taken something else with it so the amp is in for repair. I understand that tubes which test fine can become defective, it's just bad luck. But you should expect the sort of service I'm getting - no questions asked, it's being fixed.

Just for information - the tube in my amp arced inside the tube and although I turned the amp off in a hurry it was dead after this (fuse blown). Now if a replacement tube is put in there is a big orange glow in the tube in the position the offending tube came from. Hope it's back soon though.

DS
More to discover