You could try boiling the belt for about a minute, then re-talc'ing it. That's what VPI recommends should be done every year. If that doesn't work a new replacement isn't much.
Enjoy,
Bob
Enjoy,
Bob
SDS question
Hello friends,
I was checking my turntable speed today using my KAB speed strobe and found that my table was running quite slow. I had the VPI SDS calibrated at 59.85hz and I thought I had the speed perfect. Today, I needed to adjust it to 60.03hz to get it dead accurate again.
What might cause such a big change to have to be made? I was wondering if it might be the weather (it has turned cold recently here in Chicago)?
Any thoughts would be appreciated.
Thanks.
I was checking my turntable speed today using my KAB speed strobe and found that my table was running quite slow. I had the VPI SDS calibrated at 59.85hz and I thought I had the speed perfect. Today, I needed to adjust it to 60.03hz to get it dead accurate again.
What might cause such a big change to have to be made? I was wondering if it might be the weather (it has turned cold recently here in Chicago)?
Any thoughts would be appreciated.
Thanks.