Satisfied with your DIY power cord?


Has any1 built a power cord and really satisfied with the result?
Ok, Ok, may I rephrase it?
Has any1 built a P/C and really satisfied with the result WHEN compared with a big name brand ones?
Which brands did you compare it with and where did you buy your DIY cords from, HomeDepot?
128x128nasaman

Showing 2 responses by ardri

Yes but my DIY was a bit more costly than anything from Home Depot.
Oyaide Tunami cable and 004 plugs from VH Audio;
Dramatic drop in "noise floor".

image
image
Rja, I did connect the shield drain to the ground at the IEC end leaving it off at the Power Outlet end as I was advised.

The cost is just under $100/meter and I used 1.5 Meters. The plugs were just over $130 each. I do have two acoustic Zen PC's and tested a Siltech SPX-30. Not perhaps a very wide variety so hopefully others will offer more information.
I have it running from an Oyaide R-1 Ac Outlet into a PS Audio Duet thru which I power the Amp with the AZ Tsunami and the AZ Krakatoa feeding the Resolution Audio Opus 21. Before introducing the DIY cable I was using the stock cord which had come with the PS Audio Duet, a very thick heavy gage common electronic utility power cord much like you have with a Computer. When I introduced the Oyaide cable The apparent Volume level dropped so dramatically I wondered if I hadn't mis-wired it. It took just a little burn in and a resetting of the volume to find substantially increased firmness in Bass response and a markedly quieter background so while I didn't have extensive comparative testing I concluded I would likely not be more pleased except perhaps with the Neotech Silver cable which is nearly $1,000/meter.