Review: Furutech TF-10A Pure Transmission Fuse Tweak


Category: Accessories

I purchased this fuse mainly as a cheap power upgrade for my Burson HA-160 since I was unable to use the upgraded power cable I purchased. I figured, for the amount of money to purchase a fuse, if the benefit was as good as others had stated, then at least it's worth a shot.

Before installing the fuse I played one of my more familiar discs (Sade-The Best of Sade) just to implant the overall sound paying close attention to image depth, soundstage width, details and tone. I then powered down the system, installed the Furutech fuse and powered back up. I waited a few minutes before listening, but was interested to see what the immediate changes (if any) would be. I will just say that the first impression was a night and day noticeable difference between the Furutech and the stock fuses. There was a clearly evident improvement in 3 dimensionality of images. A tad bit more extension to the higher frequencies, although very smooth and grain-free. Also, an additional punch to leading edges that were most noticeable in the beginning of words, such as words that begin with "b","d","f", etc. Even though you know the word the singer is singing, hearing them sound it out properly is nice and a trait you may not know you miss until you hear it more correctly reproduced. I was also impressed that the tone of the amp was allowed to remain fairly balanced throughout the spectrum as well.

I then let the amp/cdp run for an additional 24 hours and listened again for any changes that might have taken place. Unfortunately, the additional extension in the highs had settled, and were a bit rolled off in comparison to my initial experience, yet still a slight improvement over the stock fuse. I am pleased to say that the other improvements were still in place. The biggest area of gain for me was the 3 dimensional images. It truly makes the difference between hearing some music and actually being able to picture the instruments and singers. Soundstaging was plenty wide with good separation. When playing my favorite metal band Opeth, I could clearly hear the guitars, bass, keyboards, drums and vocals in their 3 dimensional glory even when all members were jamming along hard and heavy.

My next test was to use my other source...an iPod. The iPod is connected via the line out connection to rca's using Wireworld cable, so it's a pretty decent source believe it or don't. Yes, there was noticeable improvements even with the limited format of iTunes material. The biggest gain again would have to be the 3 dimensional images that helped to paint a more realistic image. Positive Feedback has a brief statement about the Furutech fuses in which they use the word organic. This word I feel is as good as any I would have chosen to describe them myself.

72 hours into use and the sound remains pretty much the same as after the first 24 hours. For the price of entry, I highly recommend. It has given me improvements comparable to a good aftermarket power cable, and I do mean a good one. I might have to get one for the Primo next.

Associated gear
Burson Audio HA-160
Audio Analogue Primo CD
Sennheiser HD650

Similar products
Stock fuse installed in the amp
bowenski

Showing 1 response by thuanb

Agreed with the findings.  I've just received two small Furutech fuses for TeddyPardo PSUs, one powering a JCAT USB FEMTO card, the other powering Linkwitz electronic crossover.  Immediate listening revealed an increase in holographic imagery, sound stage depth and width, clarity.  Lower register, however, were reduced noticeably.  I left the setup on while going out for lunch, then came back after 2 hours.  Things stayed the same, gone was the overly warmth and upper bass prominence I used to get with stock fuses.

Overall, even a long way before break-in, I find the SQ much cleaner, noticeably leaner, more 3 dimensional.  Let's hope for a more balanced SQ after break-in.