Resistive loading


Ho folks, I'm looking for knowledge on phono stage resistive loading. What should I listen for as I change loading? I have a Dynavector XV1s and a Pass XP-25 and have been oscillating between 250 and 100. I have never heard this topic explained and would appreciate any experiences you have. Thanks.
joeyfed55
The lower the impedance of the load the less highs you will hear. But its important to keep in mind that its not so much for the cartridge as it is for the preamp. The cartridge and phono cable form a tuned radio frequency circuit which can be triggered into oscillation by the energy of the cartridge. The resistor detunes the radio frequency circuit so this doesn't happen.

Some preamps are sensitive to the radio frequency energy at their inputs and others are not (the ones where the designer recognized the implications of that tuned circuit). I think you will find that Nelson Pass knows his stuff and you don't need any resistor at all.
Thank you! My amp is the Luxman L509X integrated and the lowest resistance loading setting is 30 on the Pass phono, I guess I will experiment and trust my ears.
High amount of loading (meaning a LOWER value resistor) will reduce the top end which means less "sparkle" and "air" on top and more perceived bass (because the tonal balance has shifted).  I personally don't like anything less than about 125 ohms with any of the cartridges I've heard because too much of the top end is lopped off, and the very reason for having a high end MC cartridge is defeated.  

While I like it pretty wide open, some loading may be necessary, as others have mentioned, to prevent RF interference.  I helped a friend with a Hovland preamp which suffered from noise and a brittle sound that turned out to be RF related (we did not know until we opened it up that the default loading was 100k ohms, a lower setting cured all of the problems). 

In the past, loading was needed to electrically tame the rising top end of cartridges as they approached their resonant frequency.  Most modern cartridges have their peak so high up, there is no need for loading to tame the peak, as far as frequency response is concerned, but loading may help with some phono stages that are not equipped to handle the ultrasonic peak overloading the phono stage.
Proper loading can become an even trickier issue if you are employing a step up transformer.  A good discussion of this can be found in a white paper put out by Rothwell:

http://www.rothwellaudioproducts.co.uk/html/mc_step-up_transformers_explai.html

The bottom line conclusion that they come up with is not to worry that much about adding loading when using a step up transformer, concentrate more on the turn ratio to get the right amount of gain.

My phono stage comes with loading on the primary side of the step up transformer, but given the relatively high value (low loading) and the really low source impedance of my cartridge, this loading has no effect on the sound.
Most modern cartridges have their peak so high up, there is no need for loading to tame the peak, as far as frequency response is concerned, but loading may help with some phono stages that are not equipped to handle the ultrasonic peak overloading the phono stage.
Overloading the phono section due to the resonant peak activating can often be heard as a tick or a pop, which might sound like its on the surface of the LP. This is why designing the input circuit to have high overload margins is important.

If a MM high output cartridge is used, the resonant peak can be in the upper portion of the audio band if the tone arm cable has capacitance that is too high (which will lower the resonant frequency). This is why phono cables are made with low capacitance.


Its worthy of note that loading the cartridge will inevitably cause its generator to do more work to drive that load. This will cause the cantilever to be harder to flex (that energy has to come from somewhere). Potentially this could lead to tracking issues, since the added stiffness will interact with the mechanical resonance of the arm with the cartridge installed.