Can't see how you would use acoustic bass management in HT mode unless it were hooked up to Yamaha at least.Can't remember if you can use dual out's at same time on REL but yes this is a conundrum unless when you kill the Yamaha the pre's out of Krell just kick in (though you would need to change level in back for Krell).Spacing for a moment bu as can't remember if REL has Neutrik or line level and speaker level connectors.Guess I would use Neutrick with Krell and line level into Yamaha.But can't see in this set up how you could use speaker level connection to sub out of Krell.Maybe RCA cable splitter and just pull out of Yamaha during Krell only operation.Dunnoh without sitting and playing with it and seeing how you have throughput set up but imagine it uses variable pre out.In any case it will probably necessitate pulling or switching set of RCA's.Good luck.
REL with Integrated Amp connection Question
This is a very noobish question but then again I'm a noob with subwoofers integrated with 2 channel systems =)
Assuming I have a Krell integrated and a Yamaha HT receiver. I have two speakers, I'd like to integrate a REL subwoofer. Currently I have the Krell as my dedicated two channel amplifier connected to a DAC and transport; however I also use the Krell to power the two front speakers and use the Yamaha AVR as a processor and video switcher via Krell's HT by-pass function. Confused yet? Now I ask you how in the world can I connect a REL sub like the Q-108 into the mix? I'd REALLY hope it can be done somehow through the Krell's pre-out line level outputs and not through the speakers terminals where I would then have to run speaker wire (thick Harmonic Technology) to the Subwoofer.
Any help would be GREATLY appreciated.
Assuming I have a Krell integrated and a Yamaha HT receiver. I have two speakers, I'd like to integrate a REL subwoofer. Currently I have the Krell as my dedicated two channel amplifier connected to a DAC and transport; however I also use the Krell to power the two front speakers and use the Yamaha AVR as a processor and video switcher via Krell's HT by-pass function. Confused yet? Now I ask you how in the world can I connect a REL sub like the Q-108 into the mix? I'd REALLY hope it can be done somehow through the Krell's pre-out line level outputs and not through the speakers terminals where I would then have to run speaker wire (thick Harmonic Technology) to the Subwoofer.
Any help would be GREATLY appreciated.