Quatro Wood setup help

I am using Vandersteen 5A's which are quite similar.  While you're waiting for the setup person, if you have all the controls in their central position, you will have achieved 92.7% of your setup.  The one critical adjustment is to the high pass filters....they should be adjusted for your amp.  Let me know if you need a deeper understanding of it.

no need to get a audiophile approved power cord for the Vandy’s......there will be no difference...even if you could connect it...  just read that Johnny set them up....don't touch them they're perfect.

If you're concerned about leveling...use a penlight laser (very cheap on the internet), a couple of post-it stick-ums and a pencil.  Place the penlight laser on the flat op of the speaker slowly move it left to right, until you can see the red laser dot behind your seated position.  Put the post-it on the wall where the dot is and mark it with the pencil.  Do the same thing to the other speaker...you will see the laser above/below the dot on the wall.  Adjust one speaker so that the laser falls directly on top of the dot of the other speaker..   The speakers are perfectly aligned.