PS Audio GCPH and Pass X0.2 not talking?

Ghostrider,

Because I've tested each one: the 'table plays when connected straight into my headphone amp; the GCPH plays when connected straight into my power amp; the X0.2 plays my CDP with no issues.

Even with the volume turned all the way up...way past 6:00, there's no sound. As I said, there's no apparent signal coming out either through the phono preamp, or the preamp.

Audiofeil,

Yep, correct MM/MC are being used. Checked all the gain and impedance settings but nothing makes a difference. It's as if the signal from the GCPH isn't being recognized by the X0.2. Never had this problem with my other preamp.

Audiomax,

Tried that, as noted earlier. The GCPH is definitely putting out a signal when I connect it directly to my power amp. So, it makes no sense why the X0.2 isn't getting an input signal, or outputting it.

Robbyg,

Tried that: Silence.

Me thinks it's got something to do with the signal coming out of the GCPH and how it's being recognized by the X0.2.

Audiomax,

Thanks for the suggestion of using a volt meter. I'll see if I can find one at Radio Shack.

Stan,

I'm in touch with Kent at Pass. So far, he's pretty baffled, too. Contacted PS Audio, as well, and they haven't a clue.

Audiophile,

I tried scenarios using single-end as well as balanced (when possible). Everything seemed to function either way. So, RCA from GCPH-to-RCA into headphone amp was OK; balanced from GCPH-to-balanced into power amp, also OK.

Ghost,

The signal source on the GCPH direct into the power amp was from the turntable.

Tried all four gain settings on the GCPH with no difference (no sound at all).

Tried Inputs 1 and 2: No sound. Immediately swapped out the GCPH and hooked up my CDP: Perfect sound.

Same as above: Selected each Input but nothing happened. Checked "Mute" too; it was off.

Taking the GCPH to a friend's house tomorrow to see what happens when hooked up to his equipment. I'll report results.

Dpac,

Until this week, I'd never connected the GCPH to the X0.2. However, the GCPH did work with my old preamp, a SF Line 3. The GCPH has been sitting unconnected for about five months.

AC power connections are all good. Everything powers up. Same outlets, same power conditioner, same PCs.

Audphile,

Tried different inputs, same response: nothing. Tried same input with CDP (got sound) and GCPH (got no sound).

I'm beginning to think the GCPH is the problem. I talked with Kent at Pass and he said if I plugged the GCPH straight into the power amp, the output through the speakers would be at ear-bleed levels, since there's no preamp buffer. Instead, with the gain on the GCPH cranked all the way up, I get barely a whisper. So, this leads me to believe something in the GCPH's output/gain is not working.

Audphile,

The settings are correct, so I agree that it comes down to a fault with something inside the GCPH.

Will do.

I took the GCPH to a friend's house today and connected it to his system: Problem duplicated. Still no clue what's causing the failure in the unit, but at least I narrowed things down to one source. The unit goes back to PS Audio for inspection tomorrow.

The folks at PS Audio and Pass have been great about communicating with me and trying to solve the problem. Many thanks to Barrows and Kent--and all you great Audiogoners!

This is an update regarding the problem I was having with the GCPH:

Sent the unit back to PS Audio.

The technician there said the circuit board was totally fried and he'd never seen a unit so badly damaged. Since I had virtually never used the unit, I was baffled. He said it was so badly damaged he couldn't even tell me what caused the problem. All I can assume is the fellow who sold it to me (on Audiogon) either mucked up the unit or Parts Connexion screwed up the mods, resulting in some sort of electrical malfunction. (I've had terrible luck with quality Parts Connexion quality control, so this wouldn't surprise me).

The good news is PS Audio fixed the unit and didn't charge me a dime. This is outstanding customer service and I'm extremely appreciative how Barrows Worm and his company handled my problem.

Many, many thanks!

Drubin,

Yes, the two weren't working together because the GCPH wasn't working. They mate perfectly now. No problems.