Proceed AVP2 and Mac MC501 remote power control


Hi all,
I need to connect the remote power control cable from the AVP2 to the MC501s, but AVP2 output is 12V and the MC-501s only accept 5V. Any simple mod (with voltage regulator?)need to be done to make them compatible?

Thx.
HH
romong
Call Harman, the should be able to help you.

From the manual:

The default settings from the factory are as follows:
•trigger 1 = 12V level when not in standby (0V when in standby)
•trigger 2 = 12V level when not in standby (0V when in standby)
The three switches that determine what combination of 5V, 12V or relay your AVP2 uses are located inside your AVP2 and must be set by a qualified installer.