Did you try powering it up with no cables connected to it? This would rule out the amp. Did you check the speaker cables at the speaker ends too, or just the amp end?
Proceed AMP5 in protective mode
My Proceed AMP5 has a flashing standby light. According to the manual, this means the amp has gone into protective mode. I shut it on and off but no joy. Checked speaker wires and no shorts. The amp is plugged into a Monster power bar. No apparent power surges or lighting etc.
Doesn't seem to be a reset button outside like most amps have? The manual suggests calling tech support. (What support from HK!?!?!)
Has anyone had a similar problem. Does anyone know if there is a reset switch inside? Does HK still repair Proceed gear?
THanks for any info or suggestions.
Doesn't seem to be a reset button outside like most amps have? The manual suggests calling tech support. (What support from HK!?!?!)
Has anyone had a similar problem. Does anyone know if there is a reset switch inside? Does HK still repair Proceed gear?
THanks for any info or suggestions.