2. home-theater
  3. 1144075425

Problems with Arcam Gear/U.S. Distributor

Has anyone recently purchased ARCAM gear and been unable to receive technical support from their U.S. distributor, ASL group? I am trying to trigger a P80 amplifier used for Zone 2 from an AVR 300, which requires you to splice a stereo mini jack to a mono mini jack (ring is trigger for Zone 2 on the AVR300). I still can't get it to trigger. I bought a fair amount of ARCAM gear recently, and while it sounds very good, the technical support is one of the worst I've encountered in any audio line. If anyone has suggestions, please advise. Thanks.
robk

Showing 1 response by bignerd100

bignerd100
515 posts
 
Splicing a mini plug to use as a trigger is fairly easy.
Just make sure you strip back plenty of wire on the mini-plug. The wires are so fine that unless you have quite a bit to wrap around they are likely to break.

Many pre/pros also require that you dictate when the trigger is in use. THis is very useful for setting up elaborate systems. Check the menu of the pre/pro to see settings for trigger outputs.

Also double check to see that you haven't connected to the trigger INPUT of the pre/pro.

Good luck!
More to discover