Does this occur after playing it for a while or as soon as you turn it on? I am just guessing here, but it sounds like it is going into some sort of thermal overload and is shutting itself down!
8 responses Add your response
Turn it up a "1/4" from what level? You say it works fine at "moderate volume". I'd have to agree to the amp shutting down via a protection circuit. If what you are experiencing is not a result of you trying to get higher SPLs than the system is capable of: You may have a defective protection circuit. Contact Dennis Had at Cary([email protected]). I've found him to be very helpful/customer oriented. |
This is the feedback I got from Cary "I spoke to my Designer. The volume in respect to the speakers may be to high in regards to the signal being fed to the CAD 500MB's which could be causing an over current condition therefore the reason the units are shutting down when listening at extremely high levels this being that the circuit overload protection circuit is kicking in and protecting the CAD 500 MB's. One suggestion is that by turning down the Right and Left channels of the SLP 05 by the input level knobs which would give you more range on the volume knob." |
Samaba, adjusting the preamp channel controls is really just a balancing act (no pun intended) but it doesn't solve your problem, it only allows you to turn the volume contol further to the right because you decreased the signals to the channels. I hope I am wrong, but I think it is going to happen again, except maybe this time it will be when your volume control may be at 1/6. Just for the hell of it, check to make sure all of your cable connections are secure. |