Jbatlanta- There is a much more economical soltn. Just parallel the inputs buy soldering a jumper across them. If you are not sure how to do it, first check with the manufacturer to make sure there is no unusual circuitry involved; if not and you're still not sure how to do it, have any repair shop do it for you. I had it done by SMcAudio when they moded my amps to Rev A, and I ran them vertically bi-amped, biwire, just as you describe. There, I just saved you at least a kilobuck (or maybe 2, those suckers are way out of my reach)!!! You're welcome ;~)
Pre-amp cables of different length? Or not??
Looking to replace the interconnects from pre-amp to the two amplifiers (ie. 4 cables).
As one of the amps sits above the other in the cabinet (well ventillated and not a problem) it would only require a 1 meter cable run. The other amp would require 1.5 meters to reach.
Since I'm planning Valhalla, this 'extra' half-meter is expensive. Should I 'economize' or buy 2 of the 1.5 meter lengths?
As one of the amps sits above the other in the cabinet (well ventillated and not a problem) it would only require a 1 meter cable run. The other amp would require 1.5 meters to reach.
Since I'm planning Valhalla, this 'extra' half-meter is expensive. Should I 'economize' or buy 2 of the 1.5 meter lengths?