I use a Target stand as well. What I have done is simply loop some string or twine over the horizontal part of the frame above the cord and tie it, allowing enough room for the bottom part of the loop to fit under the iec connector of the cord. You can then slide the loop above a little further away from the cord after you've attached it to your component to snug up the loop below the iec to give you exactly the right amount of support.
Power cord question
What are some good ways to keep after market, stiff power cords connected straight and true to the component? the sheer weight of my new Virtual Dynamics Power 2 cords is making them difficult to keep where I feel assured they are properly attached.
Components are stacked in a Target stand.
Thanks!
Components are stacked in a Target stand.
Thanks!