2. cables
  3. 129730-34305

Power cable

I’m going to start replacing my power cords. Any recommendations where to start? I’m on a budget so I’ll need to purchase one at a time. I just purchased a Transparent Premium Powerlink as a start. Thoughts on the most critical area to put it. Should it be placed powering my Levinson amp? Initially I thought either it could per the amp or preamp or dac etc. This when I started thinking and realized i have a Furman Elite 15 power conditioner. My Proceed AVP 2 preamp, Ayre Codex DAC and Bluesound Vault are all plugged into it. The only thing, it has an attached power cord. If that cord was replaced with a quality cord, does this eliminate purchasing separate higher end cords for each piece? Is there a way to do this?  Looking to be as economical as possible without sacrificing sound quality.
128x128luvrockin

Showing 1 response by jafant

jafant
18,802 posts
 
luvrockin-

there are some very good info/suggestions from the panel.
You are wise to start w/ replacing power cord(s) (PC) first.
This is the 1st step and the proper way to elevate your system's performance.

I am a "cable" guy first and foremost. Cabling is most certainly the over-looked/forgotten component.  Very important to get it right.

For your gear w/ a stock PC and you wish to replace it, an IEC connector is required in doing so.  I am a big fan of Transparent Audio cables/cords.
I would place them on the amp and pre-amp.  Then, listen for several weeks minimum prior to any more additions.  Follow the advice on the Ayre piece. Also, consult other Furman owners prior to replacing that PC as well.

You are off to an excellent start! Have fun and enjoy the music.
More to discover