Creek amps do the same. I guess some mis-design there.
Pop/crack on power up, followed by audible tweeter hiss
Hey there, looking for a little advice before throwing money at this issue. I recently installed an integrated amp (nuprime ida-8) in my 2.1 system. When I power up the amp I get a pretty loud pop/crack noise from the speakers followed by a hissing noise from the tweeters that's quite obvious near the speaker and just audible from my listening position. This happens regardless of input, mute toggling, and is independent of the volume level. The amp is plugged directly into the wall (tried multiple outlets). I've been googling, and ruled out some things:
-Disconnected everything on the amp other than power and the l/r speakers
-Unplugged everything else in the house, shut lights off etc
-Made sure the speaker wires weren't touching anything
-Tried two different amplifier units
-Tried 'cheater' plug on the amp power cord
None of this had any effect. Previously I had a pure class-d integrated for a time that was dead silent. I'm in a fairly old apartment building so I don't have any control over the wiring. Is the next step to think about power conditioners or some other device? Any input appreciated. Thanks.
-Disconnected everything on the amp other than power and the l/r speakers
-Unplugged everything else in the house, shut lights off etc
-Made sure the speaker wires weren't touching anything
-Tried two different amplifier units
-Tried 'cheater' plug on the amp power cord
None of this had any effect. Previously I had a pure class-d integrated for a time that was dead silent. I'm in a fairly old apartment building so I don't have any control over the wiring. Is the next step to think about power conditioners or some other device? Any input appreciated. Thanks.