I really believe there should be a pictorial guide on " The many ways to hook up a sub" sell it for $5.00 right here on Agon.
NOW TO CONFUSE YOU EVEN MORE
The AVR200 should run fine using line level for stereo listening but perhaps there is something I don't know about the AVR 200. Do you have "Pre Out" jacks on the back of the AVR? I have used the "Pre Out" RCA jacks on an integrated amplifier, pluged it into the sub L R line level with good results. Then you could contine to use your Bi-wire cables.
All the sub needs is for the signal to go from the source ( the AVR 200 ) then to the sub, no significant power is transfered since the sub has it's own amplifier ( You probably know that).
IF you wanted to use the High Level input to your sub you can run a set of speaker wires from your AVR, hook them up to the sub "High Level in" then run a set of speaker wires from your sub " High Level OuT" to the speakers. You probably couldn't use your Bi-wire cables then.
You can however continue to use your bi-wire cables for your 602's Connect an additional set of speaker wires to your AVR ( You have option of using spades or bare wire? ) I am assuming your Bi-wire cables are bannana plug variety? Connect the speaker wire to the high level on your sub but this time don't connect speaker wire from the sub to the speakers. Set the sub crossover to about 60hZ and you should be off and running.
The B & W 602 S3 I believe extends down to 53hZ so I would dial in the sub crossover to right around 60hZ or just a hair lower.
As far as speaker cable goes..we need a book for that one too.
good luck
shoe
NOW TO CONFUSE YOU EVEN MORE
The AVR200 should run fine using line level for stereo listening but perhaps there is something I don't know about the AVR 200. Do you have "Pre Out" jacks on the back of the AVR? I have used the "Pre Out" RCA jacks on an integrated amplifier, pluged it into the sub L R line level with good results. Then you could contine to use your Bi-wire cables.
All the sub needs is for the signal to go from the source ( the AVR 200 ) then to the sub, no significant power is transfered since the sub has it's own amplifier ( You probably know that).
IF you wanted to use the High Level input to your sub you can run a set of speaker wires from your AVR, hook them up to the sub "High Level in" then run a set of speaker wires from your sub " High Level OuT" to the speakers. You probably couldn't use your Bi-wire cables then.
You can however continue to use your bi-wire cables for your 602's Connect an additional set of speaker wires to your AVR ( You have option of using spades or bare wire? ) I am assuming your Bi-wire cables are bannana plug variety? Connect the speaker wire to the high level on your sub but this time don't connect speaker wire from the sub to the speakers. Set the sub crossover to about 60hZ and you should be off and running.
The B & W 602 S3 I believe extends down to 53hZ so I would dial in the sub crossover to right around 60hZ or just a hair lower.
As far as speaker cable goes..we need a book for that one too.
good luck
shoe