2. amps-preamps
  3. 1399826795

Pass Integrated to Pass separates

Hello - I'm considering upgrading my pass int-150 to xp-10 and XA.60.5's (maybe even 100's). The problem I'm facing is my source components aren't the best. I have a vpi scout 2 and a ps audio phone pre, although (this is embarrassing) most of the music I listen to is through sonos. I'm wondering if this upgrade might be pointless and I should instead upgrade my source components first (cd/dac and phono).

One thought I had was to do the upgrade as planned and get an oppo 105 to hold me over until I'm ready for a big boy digital source. The truth in all of this is I'll probably continue to primarily listen through sonos (sorry I love it). What I'm really after is just more of the pass sound, I can't get enough, it's intoxicating. Just wondering if some better quality sources would be more appropriate and I'll get more satisfaction from them alternatively to the pass separates.

I appreciate any advice from the community.

Thanks!
skyflyer04

Showing 1 response by tomcy6

tomcy6's avatar
tomcy6
2,532 posts
 
The XA60.5 amps may work with your Theos. The amps deliver 60 watts of Class A power at into an 8 ohm speaker, then they switch over to Class A/B mode and can deliver about 130 watts into 8 ohms.

Here are the measurements that Stereophile got from the XA60.5s:

"The needle of the front-panel meter remained just to the left of 12:00 at 8-ohm powers below 60W. At 60W it moved slightly to the right, reaching 1:00 at 100W into 8 ohms and 1:30 at 120W. Specified as putting out 60W into 8 ohms (17.8dBW), the XA60.5 considerably exceeded that power, delivering, at 1% THD, 130W into 8 ohms (21.1dBW, fig.4), 210W into 4 ohms (20.2dBW, fig.5), and 330W into 2 ohms (19.2dBW, fig.6). The THD starts to rise above the noise floor at high powers, but is very low at powers of a few watts with a 1kHz signal, even into 2 ohms."

I would talk to the people at Pass or Martin Logan to see if that is enough power for your Theos.
More to discover