Origin Live cartridge setup with Wally Tractor


Hi

I just purchased a Wally Tractor Universal to use with an OL arm. The OL specs are 222.7 mm spindle to pivot, 17.24 mm overhang, effective length 240 mm. The wally tractor arc for the rega arm is 239 mm. Realizing that that there will be necessarily an error in the measurement, should I aim for a spindle to pivot distance of 222mm and use the 239 mm arc or make some other adjustment ( the next arc is for an effective length of 241 mm?

Thanks for the help
ted

Showing 1 response by thom_at_galibier_design

Yes,

Work with the 239/222 arc on your Wally, and use the slots in the headshell to allow you to make the slight effective length and offset angle corrections.

In writing this, I assume that the OL arm has slots in the headshell and not holes ... to permit fore and aft as well as rotational adjustment of the cartridge?

There's quite a bit of discussion about these relationships over here: http://www.galibierdesign.com//phpbb/viewtopic.php?f=6&t=75

Cheers,
Thom @ Galibier