2. analog
  3. 161376-138283

Opinions wanted on cantilever alignment

I have a couple month old Lyra Kleos and being new to this level of cartridge I’m looking for opinions.
When I received it I aligned it with a microscope and a Mint LP protractor. While aligning the cantilever I noticed that it doesn’t come straight out of the hole in the body, it is on an angle off to the side.
Its been on my mind and I wanted to reach out to the forum before I called the dealer.
This cartridge was expensive and I want to get the most out of it.

https://postimg.cc/NLyS4nqZ
Cartridge straight on.

https://postimg.cc/nXRZ4CCK
Cantilever straight on
rushfan71
best-groove's avatar
best-groove
831 posts
 
@rushfan71
Of course, Mr. Alasdair has been the manager of the company for several years and personally responds to all emails requesting help or information.

daveyf's avatar
daveyf
2,834 posts
 
Luckily, you are dealing with a company that has been around for awhile and that stands behind its products. I bought my Kleos new from a Lyra dealer, which turned out to be a very good thing as warranty service was required. 
tomic601's avatar
tomic601
12,741 posts
 
Exactly the sort of support
i expected from Lyra. Love my Delos and it is not centered vertically until the hyper precise VTF spec is achieved. To the OP is this the new Lamda ? 
daveyf's avatar
daveyf
2,834 posts
 
@tomic601  I don't think the Kleos has a Lambda option...yet.
rushfan71 OP
291 posts
 
@tomic601 I didn't see a lambda version of the Kleos while shopping around. 
The issue with my cantilever is that it wasn't centered horizontally.
If you look earlier in this thread Jonathan Carr explained what was going on with it.
More to discover